« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: DANG, It appears the bottom seam on the stock tank was glued not soldered..

By: capt_nemo in POPE 5 | Recommend this post (0)
Mon, 18 Nov 19 4:02 AM | 24 view(s)
Boardmark this board | Pope 5
Msg. 44832 of 62138
(This msg. is a reply to 44817 by Decomposed)

Jump:
Jump to board:
Jump to msg. #

The flame is in the center about a 12" circle. Doesn't get to the seams . water only gets to around 105-108 right now, feels good......




Avatar

Realist - Everybody in America is soft, and hates conflict. The cure for this, both in politics and social life, is the same -- hardihood. Give them raw truth.




» You can also:
- - - - -
The above is a reply to the following message:
Re: DANG, It appears the bottom seam on the stock tank was glued not soldered..
By: Decomposed
in POPE 5
Sun, 17 Nov 19 5:57 PM
Msg. 44817 of 62138

Nemo:

Re: "Now it is leaking water. "
That sucks. Is it returnable, or did you alter it?

It occurs to me that even a soldered seam would leak after a while if your flame is hot enough.


« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next