« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: Made a sheet metal brake, Works great!!!

By: capt_nemo in POPE 5 | Recommend this post (0)
Tue, 21 May 19 11:36 PM | 24 view(s)
Boardmark this board | Pope 5
Msg. 32534 of 62138
(This msg. is a reply to 32511 by Decomposed)

Jump:
Jump to board:
Jump to msg. #

sheet metal doesn't need to be heated DE. Un less its very thick, then I cant bend that anyway..............




Avatar

Realist - Everybody in America is soft, and hates conflict. The cure for this, both in politics and social life, is the same -- hardihood. Give them raw truth.




» You can also:
- - - - -
The above is a reply to the following message:
Re: Made a sheet metal brake, Works great!!!
By: Decomposed
in POPE 5
Tue, 21 May 19 6:43 PM
Msg. 32511 of 62138

Nemo:

Re: "I put ZERO thought into this just started bending."
Use a torch on metal before attempting to bend it. The metal will bend easier and be less prone to cracking both during and after the bending.


« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next