« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: Made a sheet metal brake, Works great!!! 

By: capt_nemo in POPE 5 | Recommend this post (1)
Tue, 21 May 19 11:34 PM | 23 view(s)
Boardmark this board | Pope 5
Msg. 32533 of 62138
(This msg. is a reply to 32506 by micro)

Jump:
Jump to board:
Jump to msg. #

The part that folds up and bends the metal is a bed frame, with the hinges ya see. The upper hold down piece is angle aluminum.




Avatar

Realist - Everybody in America is soft, and hates conflict. The cure for this, both in politics and social life, is the same -- hardihood. Give them raw truth.




» You can also:
- - - - -
The above is a reply to the following message:
Re: Made a sheet metal brake, Works great!!!
By: micro
in POPE 5
Tue, 21 May 19 1:19 PM
Msg. 32506 of 62138

That's a mighty fine Rube Goldberg brake ya gots there Nemo! SO, your bottom that you actually bend against is made out of what? Hopefully a piece of steel? A steel bar would be ideal.
I had a few box and pan folders at the plant. Handy tools when ya need them.

Pretty ingenious idea sir !! Congrats on a job well done... Thumbs Up


« POPE 5 Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next