Forum Home | Log in | Signup | My Page | Rules | FAQ | Boards | Members | Search
« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: Hey you overclockers

By: new_sun_rising in F@H | Recommend this post (0)
Fri, 22 Mar 13 3:37 PM | 23 view(s)
Boardmark this board | Folding at Home 		Msg. 01962 of 02753
(This msg. is a reply to 01961 by BigApplePi)
Jump:
Jump to board:
Jump to msg. #

BAP,

On the 3-D thing - I'm not sure if it takes a computer re-boot or just shutting down folding and restarting it that's been kicking the GPU back into 3D - ArVee or Micro can help answer that. From past conversations, I'm not sure we know what causes the video cards to kick out of 3D.

On the other question - what to adjust - about the middle of the Precision X screen is a slider called "GPU Clock Offset" - it's a little on the sensitive side - so very carefully bump it up 2-3 Mhz. If it runs good there and doesn't error out - bump it up 2-3 more. My card was already overclocked - so I had to go very slowly like that - if your card isn't already overclocked - you might be able to bump it up 5-10 Mhz increments. Go too far, and it will error out and shut down folding on the card.

ArVee - Micro - you guys are the experts on overclocking - jump in here.

Sun :-)




Avatar


- - - - -
View Replies (1) »



» You can also:
- - - - -
The above is a reply to the following message:
Re: Hey you overclockers
By: BigApplePi in F@H
Fri, 22 Mar 13 6:50 AM 		Msg. 01961 of 02753

ArVee. Yep. It says 48C now. The project is 8071. I don't know the ppd for that, but together with project 8077 the ppd is 35k. IMP that's too low.

P.S. I don't know what a 3D clock is. The temp shows on Precision X, V3.0.x but I don't know how to use it as there are a million adjustments it seems.

« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next