« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: V2.22

By: ArVee in F@H | Recommend this post (0)
Fri, 23 Nov 12 5:28 PM | 31 view(s)
Boardmark this board | Folding at Home
Msg. 01499 of 02753
(This msg. is a reply to 01498 by BigApplePi)

Jump:
Jump to board:
Jump to msg. #

Hi BAP --

So far the only series that absolutely requires 2.25 is that awful 762x series which we had a run of yesterday due to the preferred servers being out. So that's why it ran the 2.25, even d/ling it if it couldn't find it.

Everything else, at least of the stuff we deal with will run on either one but 2.22 runs much more quickly which is the reason last week or whenever it was for the commotion of getting it back if it was gone.

Avoid the common misconception that what core is present on your machine dictates what you will be sent, it has nothing to do with it. The assignment server decides what you're getting based on your hardware and your history and that's all there is to it, if you don't have what is needed to run what the assignment server sends you, voila, it is sent to you as well.

So yup, let the dreaded 762x's finish like a good trooper, curse them soundly and say a couple begone with thee's as the finished results are uploading and when you're back to friendlier stuff, replace 2.25 with 2.22 to get back to better and more familiar speeds.

Now, why 8018 is sitting there doing nothing has nothing directly to do with the above; stop the client and restart it, should be fine after that, I have no explanation.


- - - - -
View Replies (2) »



» You can also:
- - - - -
The above is a reply to the following message:
V2.22
By: BigApplePi
in F@H
Fri, 23 Nov 12 4:25 PM
Msg. 01498 of 02753

ArVee. I must be doing something wrong. Yesterday I received 7624 on one machine and a 7625 on the other. I suspect this happened to others also as I've seen an all around point decline.

So I dropped in V2.22 onto both machines. This morning one machine is trying to run an 8018 but doesn't start. It stays at zero. Should I put back the previous fahcore_15?

The other machine is still running the 7625. I suspect the same thing will happen on finish.


« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next