« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: Got my office computer changed over to version 7

By: micro in F@H | Recommend this post (0)
Tue, 20 Nov 12 12:53 AM | 26 view(s)
Boardmark this board | Folding at Home
Msg. 01479 of 02753
(This msg. is a reply to 01478 by duittuit)

Jump:
Jump to board:
Jump to msg. #

Thanks DUIT!

Yes it is.

MAke sure your version 7 client is set to EXPERT and then you click on the configure tab and then to the far right there is the expert tab.

On the bottom of the left hand side is where you click ADD and then type in: CLIENT-TYPE on the top and: BETA on the bottom. Click save.

After this you go find your FAH_15 core in windows explorer and remove the one that is in there and replace it with the one ArVee and Mark supplied that is the 2.22 version.

Close it up and you are ready to go.

You should try it!

Micro....


- - - - -
View Replies (1) »



» You can also:
- - - - -
The above is a reply to the following message:
Re: Got my office computer changed over to version 7
By: duittuit
in F@H
Mon, 19 Nov 12 9:50 PM
Msg. 01478 of 02753

micro- was that an option upon installation?

I have been quite content with around 25,000 pts per day, but yesterday I got a 7085 that is taking over 24 hrs for 6162 points. Kind of slaughters my daily production. I guess you have to take the good with the bad, but that is pretty bad! Not complaining though, because 10 years ago these units were worth anywhere from 1-4.5 points!!!

I unplugged my other computer after installing version 7 because I received a 69 point project that would take several days. I guess the FAH program is very intuitive at this point. The turtle is officially retired.

Hope everything goes well with the surgery.


« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next