« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: New Kepler Core

By: ArVee in F@H | Recommend this post (0)
Sat, 27 Oct 12 6:51 AM | 22 view(s)
Boardmark this board | Folding at Home
Msg. 01308 of 02753
(This msg. is a reply to 01307 by ArVee)

Jump:
Jump to board:
Jump to msg. #

Grrrr, you're making me learn more about 7 than I was going to right now, BAP, lol. And reply to my own msgs. Shocked

Yes, there are Add and Remove buttons but you need to be in Expert mode. Change from Novice to Expert. Still think you're better off getting it over with and getting 7.2.9 which I suspect is how this will end.


- - - - -
View Replies (1) »



» You can also:
- - - - -
The above is a reply to the following message:
Re: New Kepler Core
By: ArVee
in F@H
Sat, 27 Oct 12 6:33 AM
Msg. 01307 of 02753

BAP, yes I know it was the gpu that wasn't running, it was in fact 7623, one of the series of WU's that addresses Kepler and requires the new software. That's why I recommended getting the 7.2.9 upgrade from the beta software section on the Stanford site, it would likely clean all this up.

If you do not wish to do this, if you're running an earlier version of 7, I believe there are Add and Remove choices to address individual slots, maybe a right click? As I mentioned I'm not familiar with 7, it hasn't been necessary so far.


« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next