« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: New Kepler Core

By: ArVee in F@H | Recommend this post (0)
Sat, 27 Oct 12 6:33 AM | 24 view(s)
Boardmark this board | Folding at Home
Msg. 01307 of 02753
(This msg. is a reply to 01306 by BigApplePi)

Jump:
Jump to board:
Jump to msg. #

BAP, yes I know it was the gpu that wasn't running, it was in fact 7623, one of the series of WU's that addresses Kepler and requires the new software. That's why I recommended getting the 7.2.9 upgrade from the beta software section on the Stanford site, it would likely clean all this up.

If you do not wish to do this, if you're running an earlier version of 7, I believe there are Add and Remove choices to address individual slots, maybe a right click? As I mentioned I'm not familiar with 7, it hasn't been necessary so far.


- - - - -
View Replies (1) »



» You can also:
- - - - -
The above is a reply to the following message:
Re: New Kepler Core
By: BigApplePi
in F@H
Sat, 27 Oct 12 5:32 AM
Msg. 01306 of 02753

Right now I've determined I'm running SMP and not the GPU. It's Version 7.1.52. I deleted the GPU WU but can't find the instructions for starting it up again.

Looks like PPD are 7400 down from 32k PPD. That's quite a drop and I'm discouraged.


« F@H Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next