« WRGO Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next

Re: I pulled that 18' jet sled out of the shop toiday.  

By: Zimbler0 in WRGO | Recommend this post (1)
Wed, 23 Dec 20 11:45 PM | 28 view(s)
Boardmark this board | Reality news,,,,,,,,
Msg. 12651 of 18626
(This msg. is a reply to 12635 by capt_nemo)

Jump:
Jump to board:
Jump to msg. #

Sounds like you need to install a real 'He-Man' type
floor. Four X Sixes ought to do it.

(Or re-inforced concrete.)

Zim.




Avatar

Mad Poet Strikes Again.


- - - - -
View Replies (1) »



» You can also:
- - - - -
The above is a reply to the following message:
I pulled that 18' jet sled out of the shop toiday.
By: capt_nemo
in WRGO
Wed, 23 Dec 20 9:41 AM
Msg. 12635 of 18626

I got it running lastnight but on starter fluid. I checked one of the carbs it the gas was like honey. It has been sitting for 2 years. Its too damn cold to be taking the carbs off and draining and cleaning the whole fuel system. When I tried to pull it out, it was like I had blocks under the wheels. The damn thing being as big and heavy as it is, Broke through the floor and was sitting on the ground. I couldn't see this with it in the shop LOL. Anyway I just got done tearing out the old floor and replacing it. Just got done 11:55 PM. I will clean up tomorrow. I have 2 small boats I need to get in the shop. They sell a lot easier then a $4000 jet sled........

Uploaded Image


« WRGO Home | Email msg. | Reply to msg. | Post new | Board info. Previous | Home | Next